[Rtai] I cannot go by RTAI-3.6 whit kernel 2.6.23
gohlx002 at umn.edu
Wed May 7 13:31:47 CEST 2008
I've had this problem for quite awhile (since RTAI-3.2 or so I think).
My workaround (that I found some where on the web) is to add
"enforcing=0" to the end of the "kernel" line in the /boot/grub/menu.lst
file (which points to /boot/grub/grub.conf). I'm sure there's an
underlying issue that I don't understand but this seems to be an
adequate workaround and everything else seems to work fine.
yfcabezas at unicauca.edu.co wrote:
> Hi!! Again
> After, I tried running my RT-task, I decided install rtai-3.6 with kernel 2.6.23, the instalacion had no problems, but when I go by the new kernel compiled to start the system appears on the screen:
> Booting 'Fedora Core (2.6.23-rtai)'
> Filesystem type is ext2fs, partition type 0x83
> karnel /boot/vmlinuz-2.6.23-rtai ro root=LABEL=/, hgb quiet
> [Linux -bzImage, setup=0x2800 , size=0x1873c8]
> initrd /boot/initrd-2.6.23-rtai.img
> [Linux-initrd @ 0x1bf80000, 0x5fa66 bytes]
> Uncompressing Linux ... OK, booting the kernel
> Red Hat nash version 4.1.18 starting
> Enforcing mode request but no policy loaded, Halting now
> kernel panic-not syncing: Attempted to kill init!
> What is your opinion??
> My distro is the same Fedora Core3
> I need your help again!!
> Yonny Fernando Cabezas Ortiz
> Ingineering Automatic Industrial
> University of the Cauca - Colombia
> MENSAJE ENVIADO CON WMAIL 1.01
> UNIVERSIDAD DEL CAUCA
> Rtai mailing list
> Rtai at rtai.org
More information about the Rtai